NEJE Master power on laser 24/7 I need full control of the laser activity

laserGRBL for NEJE machine
Post Reply
laserwurks
Posts: 1
Joined: Fri Nov 19, 2021 9:39 pm

NEJE Master power on laser 24/7 I need full control of the laser activity

Post by laserwurks »

NEJE system seems to leave power on laser all the time even during engraving from on object to the next.
I have adapted a DPSS 4 watt Laser system from Endurance to my Master 2s. I use Lightburn for all engravings.
This DPSS laser leaves engraving marks with the .01% power from NEJE engraver system leaving .01 voltage on all the time.
I need to be able to run the laser with power on and off and be controlled via lightburn. Light burn has on and power setting for focusing.
I know NEJE is using GRBL firmware my question is via uploading grbl firmware not provided via NEJE will this hurt the system?
I was thinking the firmware is set to leave power on at .01% and with different programed firmware this would allow user to turn on the power for focus and light burn or other programs to engrave and have power off over white areas of the engravings.
Post Reply