Master 2S It is recording the temperature drops to zero and is stuck

NEJE MASTER 2S (170 x 170mm) laser engraver & cutter
Post Reply
LEON
Posts: 8
Joined: Wed Aug 11, 2021 8:04 am

Master 2S It is recording the temperature drops to zero and is stuck

Post by LEON »

Esta grabando la temperatura baja a cero y queda pegado... No te enviaré video porque es el mismo video y la misma situación de siempre
Cuando el láser se prende queda la luz roja y azul encendida... Ahora también enciende la verde que dice "tilt", y las últimas veces a grabado con esa luz encendida
Y siempre es lo mismo.... Comienza a grabar baja la temperatura y queda pegado
LEON
Posts: 8
Joined: Wed Aug 11, 2021 8:04 am

Re: Master 2S It is recording the temperature drops to zero and is stuck

Post by LEON »

Image
dav
Site Admin
Posts: 113
Joined: Sat Nov 21, 2020 4:00 am

Re: Master 2S It is recording the temperature drops to zero and is stuck

Post by dav »

NEJE software will read the temperature of the laser module, which is normal and will not affect the equipment machinery; if the temperature is too low, it may cause the timing belt to be too tight and affect the mechanical sliding, you can solve this problem by adjusting the synchronization belt;
Post Reply